BRAKE PRESSURE SENSOR CODE , SLIGHT PULL ON BRAKE APPLICATION

R

Rod Kirkpatrick

New member
#1
Messages
2
Reactions
0
City
Huntingtown
State
MD
Country
United States
What I Drive
2005 xc90 2.5L Turbo
#1
Hi all, I am hoping someone can provide some insight to an issue I have with my 2005 2.5L auto xc90 the vehicle has DSHC, SKID CONTROL and ABS. I have a brake pressure switch code and the car has a slight pull to the right on initial brake application. The scan data indicates a small difference in pressure between front and rear brake pressure sensors. I see the master cylinder is designed for diagonal brake application. My question is, shouldn't the brake pressure sensor values be the same?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S XC90 Parking Brake General Automotive Discussions 0
E Brake system assist Volvo XC90 (First Generation) 1
1 03 XC90. Having ebrake issues. General Automotive Discussions 0
S Question on brake job torque specs Maintenance, Warranty Issues & Troubleshooting 1
R Planning to Purchase Certified 2017/2018 Volvo XC90 (concerned about reliability issues on Infotainment/brakes/water leakage from moonroof) Volvo XC90 (Second Generation) 1
R Planning Purchase Certified 2017/2018 Volvo XC90 (concerned about reliability issues on Infotainment/brakes/water leakage from moonroof) New Member Introduction 1
M Seat belt and automated parking brake Volvo XC90 (Second Generation) 8
dloftis Rear brakes replaced at 28k miles? Volvo XC90 (Second Generation) 16
satrya Matching dead pedal for R-design brake & throttle pedals: DIY Volvo XC90 (Second Generation) 5
satrya Easy install. XC90 R-design trim gas and brake pedals Volvo XC90 (Second Generation) 4

Similar threads

Volvo Community Posts



Top